A homeowner could find mold in their home that could lead to property damage or health problems. Mold can grow on any surface, including carpet and clothing. It may also develop in places that are hard to detect, such as in the walls or over ceiling tiles.

The growth of mold can be caused by excessive moisture. It is best to control the moisture levels in your home. The below tips will help you in maintaining humidity and, as a result, prevent the growth of mold.

Cleaning Mold From Your House

1. Locating and Fixing Potential Problems

While securing your home against mold may not be feasible, you can lower the chance of developing the condition by taking care of the most sensitive and humid areas. This means checking your sump pump and gutters, fixing pipe and window condensation, and removing carpets and furniture that have been damp. Some home restoration companies are offering help for mold remediation.

2. Clean Surfaces

Clean all surfaces that are prone to mold using a stiff brush, hot water, as well as an ammonia-free soap or detergent. Use a dry vacuum or mop sponge to catch the liquid. Rinse the area well and dry thoroughly.

3. Cleanse Surfaces

After cleaning the affected area, mix liquid chlorine bleach and water to clean walls, ceilings and floors. Follow all instructions for bleach and warnings. When using bleach, make sure to open windows to breathe fresh air, and the bleach won’t harm your lungs.

4. Dry Wet Areas

Mold thrives on humidity; therefore, it is crucial to eliminate moisture and wetness. Seepage and spills must be cleaned up promptly, and if your home has been flooded and you need assistance from a professional for restoration of water damage. It is also possible to make sure your home stays dry by cleaning the bathroom walls and floors after every shower and avoiding leaving sticky residue on the floor. You can find out how to prevent household water damage in winter to help you prevent mold build-up.

5. Ventilation

Good ventilation can help decrease the amount of moisture in your home, especially in high-moisture places like the bathroom and kitchen. Ventilation equipment like the stove and dryer should be vented outside the house, not in the attic. You can increase the airflow by opening windows and using an air conditioner, dehumidifier, or both.

6. Mold Resistant Products

You should think about using mold-resistant sheetrock or drywall when renovating or building a new home. Mold-resistant drywall is not like other drywall. It’s non-paper and can be utilized in high-moisture areas such as the basement, kitchen, laundry room, and bathrooms.

7. Maintain your Gutters Clean and functional

The gutters have to be in good condition so rainwater can flow correctly and out of your house. If the drains become clogged and overflow, it could result in water accumulating on the roof or near the foundation of your home.

8. Reduce Humidity

The home you live in should not be humid to the point of 60 percent. It is recommended to keep it within 30 to 50 percent. A moisture meter is utilized to check the humidity levels in your home and for signs of high humidity like condensation.

If mold develops within your home, it may be a severe issue. If you take the most straightforward steps to regulate the moisture level, it is possible to stop mold from growing. Contacting a mold remediation expert like mold restoration in Sarnia if your home is already infected is imperative.